Bedford CF-UK Message Board Logo [Home] [Search] [FAQ]
Bedford CF-UK Message Board > CF Questions > clutch
[Private Message] [Register] [Profile] [Member list] [Log-in]
Who's Online:
There are 0 member(s), and 1 guest(s) online.
 
[Printable Version] [Post Reply]
Author Message
Anon
Deleted
Posts :
Location :
Status    : Offline

clutch

anyone know were I can get a clutch plate for my cf250 its a 83 2.3 with a 4 speed box
Sun 29 May 2016 @ 22:11 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Clutch plate.

Hi Joe,

I bought one from a site on e-bay called (mad-armadillo-trading) for twenty pounds, brand new and still in the box 245mm dia. ten spline with a twenty five mm centre which will match your gearbox input shaft.

doujoy

----------------------

Mon 30 May 2016 @ 21:18 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

I think they have one now that is suitable but it a 125 pounds I will keep looking have you got a nut to hold in the gearstick that would suit the gearbox I got of you the one in the van is a push in plastic clamp to hold gearstick could I change the whole think the gearstick goes into
Tue 31 May 2016 @ 10:57 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Gearstick.

Hi Joe,

To change over the gear-change turret you would have to strip down quite a large part of the gearbox, I will try to find a gear-stick retaining nut over here for you and keep an eye out for a clutch plate.

doujoy

----------------------

Tue 31 May 2016 @ 17:12 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

thanks doujoy that would be great
Tue 31 May 2016 @ 22:16 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Clutch plate.

Hi Joe,

I need you to measure your clutch plate cross the centre and tell me if it is 215mm or 232mm or 241mm the 2.3 slant engine normally has a plate size of ether 232mm or 241mm, the 1.8 slant engine has a 215mm with a smaller clutch cover.
And I have managed to find you a gearstick retaining threaded nut for the top of your gear-change turret.

doujoy

----------------------

Thu 02 Jun 2016 @ 11:46 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Gearstick nut.

Hi Joe,

I have send you a gear-stick retaining nut by post you should have it on your door mat by Monday morning.

doujoy

----------------------

Sat 04 Jun 2016 @ 12:51 Edit this messageQuote this messagePMQuote this message
Time in GMT
[Post Reply]
New posts since your last visit Administrative Functions: Open/Close/Delete Thread / Move Thread
Old post

Forum Jump:

Back to the CF-UK Homepage ][ Email CF-UK

Powered by FunkBoard vCF0.74c