[Home] [Search] [FAQ] | |
---|---|
[Private Message] [Register] [Profile] [Member list] [Log-in] |
Who's Online: |
There are 0 member(s), and 1 guest(s) online. |
[Printable Version] [Post Reply] |
Author | Message | |
---|---|---|
Anon Deleted Posts : Location : Status : Offline |
BEDFORD CF2 brake master cylinder overhall Hi,Can anybody tell me how to get the secondary plunger from the master cylinder please,first one came out ok ish,but the inner one seams fixed in ? its a lockhead dual system | Wed 03 Aug 2016 @ 15:05 |
Anon Deleted Posts : Location : Status : Offline |
Flute players job. Hi dickybrush,If you don't know a flute player plug or tape over the holes except the one behind the plunger and blow it out with an air-line, or a telescopic engineers magnet might be enough to draw it along the cylinder. Another possible way around it is to expand the cylinder with boiling water and then use a magnet to extract the plunger. doujoy ---------------------- | Wed 03 Aug 2016 @ 16:59 |
Anon Deleted Posts : Location : Status : Offline |
Many thanks doujoy i will give that a try | Wed 03 Aug 2016 @ 19:46 |
Gethin Card Holder Posts : 462 Location : east lancs Status : Offline |
to remove the inner piston you need to remove the fluid reservoir and rubber seal. once removed you will find a stop pin located in the outer inlet . you need to depress the piston to enable the pin to be removed . dont loose this pin as it needs to be reinserted when your reassembling | Mon 15 Aug 2016 @ 19:20 |
Time in GMT |
[Post Reply] | |
New posts since your last visit | Administrative Functions: Open/Close/Delete Thread / Move Thread |
Old post |
Back to the CF-UK Homepage ][ Email CF-UK
Powered by FunkBoard vCF0.74c