Bedford CF-UK Message Board Logo [Home] [Search] [FAQ]
Bedford CF-UK Message Board > CF Questions > fitting engine mounting blocks
[Private Message] [Register] [Profile] [Member list] [Log-in]
Who's Online:
There are 0 member(s), and 1 guest(s) online.
 
[Printable Version] [Post Reply]
Author Message
Anon
Deleted
Posts :
Location :
Status    : Offline

fitting engine mounting blocks

I have changed the engine on my CF 230.
but I am having difficulty in fitting the engine back on the mounting blocks.
Can anyone give me tips on how to do this.

----------------------

Thu 13 Jul 2017 @ 11:02 Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Engine mounts.

Hi Norman.

If you take a look at the mounts they are sided they must go on the correct side of the engine, the threaded pins are off set and there is a locating pin which most engage to put the mount in the correct position.
Because of the angle they sit at they are best left loose until they are through the slotted holes in the cross-member brackets, once you get the driver-side one into place the passenger-side one will be sitting on its pin use a piece of strong cord to tug it into place (saves on fingers).

doujoy

----------------------

Thu 13 Jul 2017 @ 11:15 Edit this messageQuote this messagePMQuote this message
Time in GMT
[Post Reply]
New posts since your last visit Administrative Functions: Open/Close/Delete Thread / Move Thread
Old post

Forum Jump:

Back to the CF-UK Homepage ][ Email CF-UK

Powered by FunkBoard vCF0.74c