Bedford CF-UK Message Board > CF Questions > Water ingress drivers footwear fuse box

	[Private Message] [Register] [Profile] [Member list] [Log-in]
	[Home] [Search] [FAQ]
	Bedford CF-UK Message Board > CF Questions > Water ingress drivers footwear fuse box

Who's Online:

There are 0 member(s), and 1 guest(s) online.

[Printable Version] [Post Reply]

Author	Message
Anon Deleted Posts : Location : Status : Offline	Water ingress drivers footwear fuse box Hi. Just realised in cf250 drivers foot well is getting wet Not soggy but more than just moist. After just noticing water ingress issue has been happening for some time as the fuses inside the fuse box are going rusty effecting the power the lights. Cleaned all the fuses and lights work now. Don't see any splits in the windscreen seal. Water doesn't come in huge amounts but more of a slow drip over time. Where should I begin to trace the leak. Thanks for advice in advance.
Wed 30 May 2018 @ 15:13
Anon Deleted Posts : Location : Status : Offline	Could try sealing the gap between the front drivers side guard and the body below the windscreen corner (the line that continues along the top of the bonnet gap and comes around to the wing mirror) - I put silicone along there and it stopped water leaking into the little parcel tray next to the accelerator pedal (which is just below the fusebox).
Sun 07 Oct 2018 @ 09:00
Anon Deleted Posts : Location : Status : Offline	Water leaks. Hi Wotnot, This is not uncommon and is normally from the windscreen rubber seal or the top of the inner wing where the outer wing meets the windscreen mask, directly above the fuse-box. Apart from sealing these area's I have moved the fuse-box to one side out of line of that leak risk area. doujoy ---------------------- D S Joyce.
Sun 07 Oct 2018 @ 09:01
Time in GMT

[Post Reply]
New posts since your last visit	Administrative Functions: Open/Close/Delete Thread / Move Thread
Old post

Forum Jump:

Back to the CF-UK Homepage ][ Email CF-UK

Powered by FunkBoard vCF0.74c